Hi Folks,
there are two ways to make Super Famicom Pads work on a PAL SNES.
a) You can mod the ControllerPort inside the PAL SNES and shortcut the 4 diodes with some wire.
b) You mod the controller inside
I found different PCB generations inside the SuperFamicom. A PCB copyright 1992 shows with big arrows: Only P
https://yadi.sk/i/lc9gar8D3RtFVQ
https://mega.nz/#!W00yiSyY!ZMX39LAlfQ5W ... Ngw3trEz0c
OK I have a look inside a PAL SNES Controller and shows to me: R1=1,2kOhm and R2=3kOhm.
I done a quickshot with standard Resistors and used 1,2k and 3,3k. And
Yeah a japanese Controller is working on my PAL SNES.A “older” japanese PCB from 1991 is missing the two resistor spaces. After checking the cirquits at 1992 Layout, no problem for this layout too.
Put 1,2kOhm between Pin 5 and Pin 4 and
3,3k between Pin 5 and Pin 3
of the ControllerCable Connector and it works too
https://yadi.sk/i/9J-Fflvp3RtFVT
https://mega.nz/#!SttmUbSK!h_eL9lDWsMyt ... VGSAESK7Ds
Have Fun
